Hoshizaki KMH-2000SWH/3 Instrukcja Użytkownika

Issued: 1-22-2010Revised: 5-26-2010Hoshizaki “A Superior Degree of Reliability” www.hoshizaki.com Models KMH-2000SWH/3KMH-2000SRH/3Stackable Crescent

102. KMH-2000SRH/3 (remote air-cooled)Note: The storage bin opening must match the bottom opening as in the illustration.Unit: mm [in.]

11II. Installation and Operating Instructions WARNING1. This icemaker must be installed in accordance with applicable national, state, and local regul

12C. LocationCAUTION1. This icemaker is not intended for outdoor use. Normal operating ambient temperature should be within 45°F to 100°F (7°C to 38°C

135) Install the bin control thermostat as follows: a. Remove the baffle from the bin (if applicable).b. Remove the tie securing the bin control therm

146) Conrm that the icemaker and storage bin are level in both the left-to-right and front-to-rear directions. If necessary, level the storage bin in

157) Install the bin control thermostat as follows: a. Remove the thermostat bulb attachment (plastic) of the upper unit from the thermostat extension

16F. Electrical Connection WARNINGFor All Models1. Electrical connection must be hard-wired and must meet national, state, and local electrical code r

17Fig. 7bKMH-2000SWH3KMH-2000SRH3 WARNINGELECTRICAL CONNECTIONTHIS UNIT MUST BE GROUNDEDFailure to properly ground or wire this unit could result in d

18G. Installation of Remote Condenser Unit WARNING1. Installation of remote condenser unit must be performed by properly trained and EPA-certied serv

193. Setup1) Secure the legs to the remote condenser unit with the 8 bolts and nuts provided. See Fig. 10.2) The legs have 8 mounting holes. Secure th

2IMPORTANTOnly qualied service technicians should install, service, and maintain the icemaker. No installation, service, or maintenance should be und

20c. Make sure the male tting and female coupling are properly aligned, then start the connection by hand to ensure that it is not cross threaded. d.

216) Evacuate through the Schrader access ports on the Parker quick connect couplings and charge with R-404A refrigerant vapor to a pressure of 15 to

225. Refrigerant Charge (Line Set Exceeding 66 Feet)CAUTIONThe icemaker, line set, and remote condenser unit must contain the same type of refrigerant

234) Connect the fan motor leads in the junction box of the remote condenser unit to the fan motor leads in the fan motor junction box of the icemaker

24H. Water Supply and Drain ConnectionsSee Fig. 16, 17, or 18 WARNING1. Water supply and drain connections must be installed in accordance with applic

251. Icemaker• Icemaker water supply inlet is 1/2" female pipe thread (FPT). A minimum of 1/2" nominal copper water tubing is recommended fo

262. Water-Cooled Condensera) Connection to an Open Drain System• Condenser water supply inlet is 1/2" female pipe thread (FPT). A minimum of 3/8

27Condenser Return Outlet 3/8" FPTCondenser Return Line Shut-Off ValveCondenser Return Line Drain Valveb) Connection to a Closed Loop System• Con

28I. Final Checklist WARNINGCHOKING HAZARD: Ensure all components, fasteners, and thumbscrews are securely in place after installation. Make sure that

29J. Startup WARNING1. All parts are factory-adjusted. Improper adjustments may adversely affect safety, performance, component life, and warranty cov

3CONTENTSImportant Safety Information ... 4I. Specicati

30CLOSEDNormal Icemaking OperationOPENCleaning and Sanitizing Operation(allows solution ow to the inside of the evaporator)III. Cleaning and Maintena

311. Cleaning Procedure1) Dilute 38 . oz. (1,124 ml) of Hoshizaki "Scale Away" with 7 gal. (26 l) of warm water.2) Remove all ice from the

3222) Move the control switch to the "WASH" position.23) Replace the front panel in its correct position.24) Turn on the power supply to rin

33B. MaintenanceThis icemaker must be maintained individually, referring to the instruction manual and labels provided with the icemaker. WARNING1. On

342. Drain the water tank:1) Turn off the power supply, then remove the front panel. Move the control switch to the "OFF" position.2) Remove

35HOSHIZAKI AMERICA, INC. 618 Hwy. 74 S., Peachtree City, GA 30269 USA TEL (770) 487-2331 FAX (770) 487-3360 www.hoshizaki.com 91A1SR10B

4Important Safety InformationThroughout this manual, notices appear to bring your attention to situations which could result in death, serious injury,

5MOTOR-COMPRESSOR THERMALLY PROTECTED, NOT INTENDED FOR OUTDOOR USE!Hoshizaki America, Inc.Peachtree City, GAwww.hoshizaki.comICE MAKER WITHOUT STORAG

6MOTOR-COMPRESSOR THERMALLY PROTECTED, NOT INTENDED FOR OUTDOOR USE!Hoshizaki America, Inc.Peachtree City, GAwww.hoshizaki.comICE MAKER WITHOUT STORAG

7MOTOR-COMPRESSOR THERMALLY PROTECTED, NOT INTENDED FOR OUTDOOR USE!Hoshizaki America, Inc.Peachtree City, GAwww.hoshizaki.comICE MAKER WITHOUT STORAG

8MOTOR-COMPRESSOR THERMALLY PROTECTED, NOT INTENDED FOR OUTDOOR USE!Hoshizaki America, Inc.Peachtree City, GAwww.hoshizaki.comICE MAKER WITHOUT STORAG

9Note: The storage bin opening must match the bottom opening as in the illustration.B. Dimensions/Connections1. KMH-2000SWH/3 (water-cooled)Unit: mm [